Reuse existing old ceramics ceramic needs a number of requirements for kaplayabilmek. The most important of these existing old ceramics must be solid.

This is no place to check the solidity of the hand can be also place a plastic with a ceramic tile can be polled. Tarak, suspected, or non-ceramic tiles, first over the plug even this ceramic paste at the bottom of the harcıda is not removed from there, that harçta appropriate solid repair with these places are to be filled.

After other important terms of this leveling of the joints with the existing old is required to be furnished.

If the existing old ceramic, grout is furnished in this case all of the existing old ceramics without hesitation ripped again by plaster repairs should be done and on the Corporation s existing plaster should be made of ceramic, such as ceramic coating.

Therefore, the application of a zero joint over a ceramic tile ceramic tile line is not going to have the correct results.

Another important respect, ceramic glaze layer in front of the surface. If the coating cement-based, adhesive mortar is used be sure way old ceramic layer of secrets located on the surface of it is necessary to get rid of. Otherwise, the cement-based bonding mortar surface water absorbency of surfaces grip capabilities directly proportional to. Glazed ceramic tile to the front surfaces of water to cement-based paste em mortars do not hold very well on this type of surface. Therefore, old ceramic of secrets at frequent intervals should be drawn. The best way to do this was possible, angle grinder machine secrets of existing old ceramic 45º C to be the angle of the existing field at frequent intervals over 70% more should be drawn.

While this is in progress, check this out too. Spiral stone engine in front of the knife too much deep daldırılmamalıdır. So we should not be wasting the back surface bonding of ceramics.

Should be taken only of the front surface 2 mm layer of glaze. While this is in progress a lot of mistakes, not hammer while secrets are secrets. This is an incorrect behavior. Because while this process without realizing it, we compromise the existing old ceramics. Therefore, we should not use the process certainly attractive notch.

Another important issue is the full scale of the existing old ceramics and really should pay attention to in the infinitive. To do this, with the help of a surface gauge and scales should be checked from different locations. Similarly, it must be in the full internal and external corners, miter.

After the surface layer of glaze surfaces plenty of dust. After a brush with this powder adhesive unglazed surface to increase the surface aderan Betomax UNI, Multi-purpose Performance Insole or Primerfix 101, smooth surface Coating will benefit ride.

Ceramic on ceramic prior to the application, and ensure that existing ceramic robust surface to be applied in the case of surface water will not be exposed to direct all the time Primerfix 101, smooth surface Coating may be applied. Gluing cement based or in acrylic-based, high-performance, flexible adhesives should be preferred.

Additional considerations in implementing a matter at the surface of the comb the adhesive grip angle. In terms of normal grip comb slightly lower angle. When we pull the comb teeth are a problem of the old occurrences of points in ceramic.