Water-based painted surfaces, the paint is solid and his folly in the surface of ceramic tiles in case of believe, move these surfaces a suitable primer materials, coating can be used before.

Painted surface stability, no doubt detachable, water-based or solvent-based paint painted surfaces with any ceramic tile coating is not going to have the correct results. Therefore, in these cases, we need to get rid of paint is one way.

There are several ways of getting rid of anything besides, the easiest and the simplest of these is to dig below the surface. But in any case this stripping may not occur. The main reason we scraping the paint from the surface; tutunabilme on the surface of the paint. This will make the surface normal power, ceramic tile bonding is very very low.

Water-based paints are replaced once a year, 4-5 4-5 and froth is poured or color a year or so, solvent-based paint is a little more of life is long. But ceramic tile life with these absolutely incomparable. Without any preparation is cover the ceramic tiles, ceramic tile directly over the life cycle, we synchronize the life of the paint. Therefore, when the paint begins to rise, getting up from the ceramic tile be poured with our State. That s why we need to get rid of paint before you start from hull.

This is the most practical way to hammer surface notch. This is a very technical process of notching. The hammer was not the upright pommel, pointed to the surface with a pain for nearly 30 -35 only to surfaces in their weight should be shot. An extra power should not be applied. In this way we can create nicks at frequent intervals on the surface. It s like we can do it this way, we can draw on the surface of the stone or the Palm of the surface paint on the dig. This will be much more practical and much more series. But there will be a lot of dust in the environment.

Therefore the surface after you surface spalling and boot taken later before the dust with a brush to the surface again Betomax EM2, absorbent Surfaces for acrylic-based primer or Betomax UNI, Multi-purpose Performance should be Lining. The main purpose here, so holding and adherence between the surface with glue is to enhance the Eclipse.

Another important issue is the comb used grip angle. Normally, ergonomically comb 40 -45 °-50-55 ° at an angle. But when we use a painted surface of the comb ceramic wrap our grip we need to reduce the angle is a little more than normal. The aim here is to leave more adhesive on the surface. This is the angle at which we need to zero or close to zero while lowering full hold. We can t get enough depth of teeth or. Therefore a slightly lower angle from the normal grip if we leave more mortar on the surface.

Compare here should be, must not interfere or the following painted layer of the comb passes through a layer of plaster, gözükmemelidir. We can take this base.

Of course, the painted surface before plating on surface of scales is in the infinitive are other important points. Also be used still coating adhesive mortar, high strength, flexible adhesives. In addition, under normal circumstances, made after 24 hours in coatings joint fillers, these types surfaces only side, bottom paint, adhesive mortar will extend dry time surfaces of as late as possible, 3-4 day, whenever possible, in fact, must be made within 5 days of the grout.