POLYPROPYLENE FIBER 6 mm
Product Description:
Plaster, screed, cement mortar, etc. It is a 6 mm long, polypropylene fiber placed in the mixture in order to meet tensile stresses in applications and to increase strength.
Public Works Pos No: 04.279/3G
Areas of Use:
Field Concretes:
Industrial floors, parking lots, hangar floors, airports,
Machine foundations subject to abrasion,
Water tanks, swimming pool concrete,
In thin floors,
Fees:
In all kinds of plaster, repair and insulation mortars,
Precast Elements:
In pipe manufacturing,
In all kinds of precast elements,
Shotcrete:
It is used in all kinds of shotcrete applications.
Features:
It is water and alkali resistant.
It is resistant to abrasion and increases resistance against impacts.
Thanks to its good dispersion in concrete and low segregation, its mechanical strength is high.
Since it prevents cracks, it helps waterproofing by eliminating capillary gaps where water can leak.
It prevents shrinkage caused by water loss in fresh concrete by increasing tensile strength.
Fire resistance of concrete increases.
It reduces the corrosion of metal reinforcement.
It has a low cracking tendency.
Increases resistance to fractures in concrete corners and edges.
Technical Specifications:
Appearance: White fiber
Fiber Length: 6 mm
Density: 0.91 kg / lt
Alkali Reaction: Stable
Acid Effect: Durable
Alkali Effect: Durable
Oxidation Resistance: Very good
Organic Solvent Effect: Durable
UV Resistance: Durable
Abrasion Resistance: Stable
Moisture retention: None
The above values are given for +23 ºC and 50% relative humidity.
Pre-Application Preparation:
Make sure that the application surface is cured and solid. The surface to be applied should be free from paint, oil, dust, etc. must be cleaned from materials. The sand to be used in the mixture must be clean, the cement must be fresh and not spoiled.
Application:
Betofiber PP 06 should be mixed into concrete for a normal time (Average 5 minutes) and used immediately so that the aggregate does not grind the fibers. If the application point is more than 2.5 hours from the concrete plant, the mixing process of the fiber should be done at the application point. It should be added together with other additives in dry mortar mixtures.
Warnings:
Low water / cement ratio, correct cement and aggregate dosage and curing of concrete after application are required for good results.
Consumption: 0.6 to 0.9 kg should be used for 1 m³ cement mix.
The amount of consumption is the values calculated theoretically in the laboratory environment; We recommend that consumption control sample application be made before the application.
Packing: 600 gram sachets.
Storage and Shelf Life:
Water, frost, etc. must be protected against severe weather conditions.
Safety Advices:
For more detailed information, please refer to the Safety Data Sheet.
Responsibility:
The application instructions and technical values given in this technical document are based entirely on our scientific and practical knowledge. These values may vary depending on the ambient conditions. Allmax Construction Chemicals reserves the right to make changes in products in line with technological developments. Allmax Yapı Kimyasalları cannot be held responsible for the results that may arise out of written recommendations regarding where and how the product will be used and / or due to incorrect use. Therefore, when using Allmax Construction Chemicals products, make sure that you use the right product in the right place. Allmax Construction Chemicals is only responsible for the quality of the product.
