DECORATIVE PLASTER PRIMER
Product Description:
Acrylic copolymer emulsion-based interior and exterior plaster primer that makes the absorption of the application to be applied homogeneous by the surface, allows moisture to escape due to its high water vapor permeability, prevents the formation of salt in the building, strengthens the application surfaces, and also has an effect on the covering because it is filled.
Public Works Pos No: 04.503/1
Areas Of Use:
After thermal insulation board plaster applications, before decorative plaster applications,
On absorbent surfaces such as mineral-based concrete, aerated concrete, pumice block, gypsum, gypsum,
It is also used in preparing the surface before painting any kind.
Features:
It increases the adhesion strength of the plaster to the concrete by reducing the absorbency on the surfaces it is applied to.
In thermal insulation systems, especially in the summer months, it prevents the heat insulation plaster from overheating under the sun, so it enables the application of the decorative plaster to be applied on the plaster more easily and increases its strength.
It prevents the concrete surface from absorbing the water of the plaster.
It prevents the shrinkage cracks of the plaster.
It can be applied with a brush or roller.
It is resistant to atmospheric weather conditions.
It has diffusion feature.
It does not harm human and environmental health.
Technical Spesifications:
Appearance: White liquid
Density: ~ 1.50 kg / liter
Application Temperature: + 5ºC to + 35ºC
Overcoat Acceptance: After 6 hours
Drying Time: 45-60 minutes
The above values are given for +23 ºC and 50% relative humidity.
Pre-Application Preparation:
On fully dried wall surfaces to be applied, all kinds of oil, dirt, swollen layer and sand particles in the weakly adhered plaster should be removed from the surface.
Dirty, dusty and loose textured surfaces should be cleaned.
Application:
Decomax D6, Decorative Plaster Primer is thinned by 10-20% by volume and applied as a primer on all surfaces where the products will be applied before the final layer application.
On old painted surfaces, it should be applied in one layer by diluting with emulsified acrylics at a ratio of 1: 7.
Universal binder should be applied in one layer without thinning on highly absorbent, weak and old painted surfaces. After the surface preparation process is completed, it is applied in a single layer with the application tool specified below. Brush, roller or spray method can be used for application.
Warnings:
The temperature of the application surface should be minimum + 5 ° C and the surface should not receive precipitation.
Hands and application tools should be washed with plenty of water after application.
Consumption: 120-150 gr/m²
It varies depending on the application surface.
Packing: 20 kg. plastic bucket
Storage and Shelf Life:
Protect the liquid component from exposure to sunlight and frost between + 5ºC and + 35ºC.
Shelf life is 12 months in its original packaging in a suitable environment.
Safety Advices:
For more detailed information, please refer to the Safety Data Sheet.
Responsibility:
The application instructions and technical values given in this technical document are based entirely on our scientific and practical knowledge. These values may vary depending on the ambient conditions. Allmax Construction Chemicals reserves the right to make changes in products in line with technological developments. Allmax Yapı Kimyasalları cannot be held responsible for the results that may arise out of written recommendations regarding where and how the product will be used and / or due to incorrect use. Therefore, when using Allmax Construction Chemicals products, make sure that you use the right product in the right place. Allmax Construction Chemicals is only responsible for the quality of the product.
